ELECTRICAL SPECIFICATION V3
GENERAL PERFORMANCE SPECIFICATIONS
TEMPERATURE STABILITY OF OUTPUT FREQUENCY	±2% dbw to 95KHZ (±3% dbw above 95KHZ) for cneter frequency, and bandwidth variation from a best reference frequency from -40°C to +85°C, at any input signal level.
BAND EDGE ACCURACY:	±1.5% dbw to 95KHZ (±2% dbw above 95KHZ)
LINEARITY:	±0.2 dbw, best straight line, maintained from -40°C to +85°C
TIME STABILITY:	±0.25% dbw for 8 hours @25°C after 5 minutes stabilization.
DISTORTION:	<1.0% anywhere within the passband from -40°C to +85°C
AMPLITUDE MODULATION:	<5.0%
INTELLIGENCE FREQUENCY RESPONSE:	±0.1 dB of DC response for a modulation index of 5 or greater.
INPUT SPECIFICATIONS
INPUT IMPEDANCE:	500 KW 's, +10%
INPUT VOLTAGE:	Any 5 volt range from -5 to +5 volts (specify range when ordering). Mode available when indicated on case type.
SOURCE IMPEDANCE SENSITIVITY:	<1.0% dbw for source impedance change of zero infintiy.
OUTPUT SPECIFICATIONS
OUTPUT INPEDANCE:	47 KW 's, ±10%
OUTPUT VOLTAGE:	0.325 ± 0.025 volts RMS at center frequency into a load of 10 KW 's shunted by 40pf. Output will not vary more than ±10% over the temperature range of -40°C to +85°C from a 25°C reference voltage.
MODULATION FEEDTHROUGH:	40 dB below output signal level.
POWER SPECIFICATIONS
POWER REQUIREMENTS:	+28 ±10 volts @ 4.0 ma. Max.
B+ STABILITY:	A ± 10 volts change in the B+ supply will cause a frequency change of less than ±0.5% dbw
VOLTAGE PROTECTION:	±40 volt supply voltage will not damage the unit.